PILOT RC LASER – 88″ \(2.23m\)

It has arrived! The 60cc version of our rule changing Laser!

Fully designed from the ground up for out and out performance, keeping in line with current demand for faster, more aggressive and more agile models, while still keeping the well know great flying characteristics Pilot-RC models are known for.

SPECIFICATIONS :
Model: Laser – 30%
Wingspan: 88″ \(2.240mm\)
Length: 83.5″ \(2.120mm\)
Wing area: 1,291 "² \(8,330 cm²\)
Weight: 17.75lbs \(8.0kg\) with GP61cc

FEATURES :
NEW! Full Carbon reinforced fuselage and wing using carbon laminated wood.
NEW! Patented quick assembly system for wings and elevators.
NEW! Patented quick assembly system for canopy.
Genuine German Oracover \(Ultracote\) covering
Highly prefabricated, experienced builders can have air ready in under a day
Pre-installed hinges \(glued and pinned\)
Easy canister installation due to open construction
Removable rudder \(as well as removable wings and stabs\)
Laser engraved motor mounting position
Push-Pull system and Pull-Pull systems available for Rudder servos
Cowl fits both single cylinder and twin cylinder engines! \(DA70, DLE60, GP76\)

INCLUDED HARDWARE :
Complete air frame with all basic accessories \(such as carbon fibre main undercarriage, tail-gear assembly and wing-tubes as well as fibreglass control horns and wheel pants\)
Pre-installed hinges and pre-mounted canopy
Fuel tank and fuel tubing pre-prepared, fuel dot and breather valve
Wheels, axels and wheel pants
Pre-prepared

wires and pushrods with ball links
Matching carbon spinner, 3.5″

REQUIRED HARDWARE :
Motor: 50-76cc or equivalent electric

Servos: 5 high torque \(minimum 20kg\) plus throttle // Uses x1 per aileron, x1 per elevator and x1 on rudder

Also requires all the usual accessories such as transmitter, receiver, propeller, batteries, powerbox, extension leads and possibly other small accessories.

Build information :
COWL SIZE:
A: 286mm – B: 292mm – C: 286mm – D: 308mm

EXHAUST TUNNEL SIZE:
A: 475mm – B: 106mm – C: Unlimited – D: 104mm – E: 162mm – F: 167mm

Due to the open tunnel design in the Laser, there is no backplate \(measurement C\) so there is no limit to the length of exhaust that can be used.

RUDDER HORNS AND PULL PULL LOCATION:
A: 29mm – B: 95mm – C: 52mm – D: n/a – E: 8.5mm

EXTENSION WIRE LENGTHS:
Throttle : 30cm
Each aileron : 25cm \(to reach receiver direct\)
Each elevator : 135cm
Rudder : 115cm \(when using direct – if installing pull pull, no required extension\)

CENTER OF GRAVITY : 164mm
Measured back from leading edge of the wing at the fuselage.

You will find a laser engraved C.G. emblem on the inside of the fuselage, located close to the wing tube, which also shows the exact location for Center

Gravity.