The ultra-power afterburner rings are the first thrust nozzle rings based on emitter technology on the market. Aluminum core PCBs specially manufactured for this application make the assembly of the high-performance emitters and the required power dissipation possible. In addition, a cooling rod is already glued behind each emitter in order to be able to dissipate sufficient heat during operation. Without further air cooling, the rings can be operated continuously for approx. 1-2 minutes, so the admixture to the gas duct should only take place in the upper area.

The light output of the emitter rings is huge and also visible in a range of >120 ° on all sides of the ring. This means that both the outlet and the nozzle are lit up directly, which greatly increases the effect of a glowing push tube.

Direct operation with 2S \(8V\) Lipo. Make sure there is sufficient cooling air during operation. The high power consumption of the afterburner rings requires batteries of sufficient size and a powerful control system.

This ring is delivered with two 1m / 0.5mm silicone cables. These cables can be connected to the control in parallel. With 2-channel controls, a boost effect can be generated here in order to

the afterburner ring in the uppermost operating mode with maximum power over both cables.

NEW: A matching 2nd generation nozzle attachment is included with every afterburner ring. With the cover you get a completely different light effect, especially recommended if the ring can be fully visible during operation.

Technical specifications
Power: 15 emitters with 60-90 lumens each
Voltage: 2S / 8V
Current: 2-2.5 amps Beam
angle: ~ 100 °
Dimensions inside: 60mm
Dimensions outside: 73.8mm
Weight: 33g \(without cable\)