Shaft Set for the 4015 Series Scorpion motors

The Scorpion M-4015 motor shaft kit is built with 4mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one.
For these occasions, replacement shafts for all the M-4015 and MII-4015 series Scorpion Multi-copter Motors are available.

The shaft for the M-4015 and MII-4015 motors that have the C-clip retainer.
The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note:
The shafts in the Scorpion motors are a slight press fit into the aluminum front housing.
The shafts will not just slide out when the setscrews are removed.They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.