Shaft kit scorp 65 series (12x70mm) sls
1 Offer from: R 416.00
Brand: Maytech / Scorpion / NeuModel: CSPS65
Last Updated:
Shaft Set for the SII-6530 Scorpion motors
The Scorpion SII-6530 series of motors are built with 8mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one.
For these occasions, replacement shafts for the SII-6530 Scorpion Motors are available.
The shaft for the SII-6530 series airplane motors measures 8mm in diameter, and is 115.9 mm in long.
The shaft kit will also fit other brushless motors that require a 8mm shaft of this length.
The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.
Note:
The shafts in the Scorpion motors are a slight press fit into the aluminum front housing.
The shafts will not just slide out when the metric screw are removed.
They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.