Align has extended its TB series with the new Align TB40, a formidable 400-class helicopter aiming for the 380-400 class market.
Amid Align's comprehensive model lineup refresh, the focus shifts to the TB40, boasting agility and compatibility with main blades spanning 370mm to 400mm.

While the TB40 follows the TB70's release, it's essential to highlight the recent introduction of the TB60.
Currently, detailed information is limited, with the confirmed specification being an 8mm main shaft diameter, aligning with the trusted T-Rex 500's main shaft.
This suggests the replacement kit will conform to the original 500 class, potentially slightly smaller, yet offering enhanced strength and agility.

Specifications :

●Length: 747mm
●Height: 223mm
●Width: 103mm
●Main Blade Length: 380mm
●Main Rotor Diameter: 851mm
●Tail Length: 70mm
●Tail Rotor Diameter: 188mm
●400MX Brushless Motor \(1100KV/3220\)
●Motor Belt Pulley: 22T
●Drive Gear Ratio: 6.44:1:4.04
●Max RPM \(approx.\): 3400RPM
●Frame Weight \(Batteries not included\): Approx. 953g

Included :

●TB40 Kit Set x 1 set
●380 Carbon Fiber Blades x 1 set
●70 Carbon Fiber Tail Blades x 1 set
●400MX Brushless Motor\(1100KV/3220\) x 1

Electronics and accessories required/needed to build :

●Transmitter \(6-channel or more, helicopter system\)
●Receiver/Flybarless controller \(6-channel or more\)
●RCC-6CX Intelligent Balance Charger
●22.2V 6S 1850~2200mAh Li-Po Battery
●Digital Pitch Gauge
●Multi-function Tester
●Flybarless System x 1
●CCPM Brushless Servo x 3
●Rudder Brushless Servo x 1
●Brushless ESC x 1