Emcotec A11030 - RV Mini 5 \(Please note this is the older version, not Magic\)

Redundant power supply system for servos and receiver.
Redundancy is provided by 2 batteries. If one battery is out of order, the other supplies power to the entire reception.
In normal operation, the 2 batteries discharge at the same time.
These 2 batteries are connected in parallel, meaning that the capacities are added.
We can therefore choose lower capacity batteries to save weight.
All servos plugged into the DPSI receive maximum electrical power while the receiver power supply is regulated to a lower voltage.
The DPSI comes with a magnetic safety switch.

Distribution of 5 channels from the receiver to 8 servo outputs, the other channels can be connected directly to the receiver.
Integrated "Y" function,
Up to 50A peak for optimal servo power supply.
Regulation system to work with all types of batteries.

Selection of receiver supply voltage \(5.2v to 5.9v\) and servos \(5.9v to 7.4v\)
Low loss regulators for minimum dissipation and maximum power. Protection of the receiver of the "Dynamo" effect
APP: Push-pull amplification of the servo signal, ideal for 2.4ghz systems
HFIB: High Frequency Interference Blocking rejects interference for servo extensions.
IVM: Intelligent Voltage Monitoring with integrated status and alarm. Easily

for all types of batteries: NiCd, NiMH, Li-Ion, Li-Po or LiFePo4

The strong points :

Dual power function
Inter electronic "failsafe"
Voltage regulation for all reception elements
Inter magnetic
Current distribution with HF filtration
An acoustic and visual alarm allows you to control the battery voltage
High-strength ABS housing

Features :

Power supply: 5, 6, \(7\)-cell NiCd / NiMH Cells, 2-cell Lithium-Ion batteries, Lithium-Polymer batteries, LiFePo batteries
Supply voltage: 5.0V to 13V
Ideal voltage: 6.0V to 8.4V
Receiver output: 5.2V to 5.9V selectable
Servo Outputs: 5.9V or battery voltage selectable
Consumption on OFF: ~ 1µA per battery
Consumption on ON: ~ 55mA in total
MAX current at 5.9V \(15 minutes with LiPo batteries\): 5A
MAX peak current at 5.9V/10 seconds with LiPo batteries: 50A
Voltage loss at 4A: 0.4V
Maximum dissipation: 8W
Number of servos: Up to 10 servos on the complete system
EC: 2004/108/EC
Weather conditions: -10°C to +50°C
Temperature: -25°C to +85°C
LCL filtering \(EMI\): For each servo noise suppression: at 35MHz - 20dB and at 100MHz - 34dB
Dimensions including battery outlets: 77 x 99 x 15.8mm
Screw diameter: 4 x 4.2mm
Hole spacing: 78.7 x 67.7mm
Weight: ~ 105g

ATTENTION: The system works with a "Hall" effect, the sensors can be affected by magnetic fields.
The switch may go OFF if exposed to a strong magnetic field.
Power cables also generate a magnetic field. Be

when passing power cables with a distance of 3cm from the switch.