>  Hobbies  >   Equipment  >   Accessories  >  Decoder 5 simprop gigabus 2.4g sls
Decoder 5 simprop gigabus 2.4g sls


Decoder 5 simprop gigabus 2.4g sls

1 Offer from:   R 568.00

Brand: Simprop
Model: RSRD5
Last Updated:

Product Information

Compatible with all GigaScan receivers from firmware 2.x
Compatible with the Futaba servo bus
Also for FASSTest receivers
Also for SRXL*

• Channel assignment programmable via setup button
• further programming with PC-GigaScan software
=> channel assignment, dual rate, cycle time , Failsafe can be set for all channels, etc.

*= The GigaBus Decoder 5 now also understands the serial servo output SRXL.
By connecting to the SRXL interface, the cabling in the model can be significantly simplified.

Note: The SRXL protocol does not allow channel expansion.

With the GigaBus Decoder 5, up to five servos can be connected to the GigaBus connector of the GigaScan receivers \(from firmware 2.x\) or the SRXL output* of many receivers.
With the GigaScan receivers, for example, the number of channels on a GigaScan 5 can be increased to 9, and a GigaScan 9 can be expanded to 13 channels.
The GigaBus Decoder 5 also enables significantly simpler cabling in the model.
For example, all servos in a wing can be connected to a GigaBus Decoder 5, so that only a single three-wire cable needs to be routed from the wing into the fuselage.

Technical data :

Servo outputs: 5
Operation/display: 1x setup button, 2x status LEDs
Operating voltage range: 3.5=8510 V
Internal current consumption: approx. 30 mA
Max. permissible continuous current of

connected servos: 5A \(5 sec. 10A\)
Connection cable: 3x 0.50 mm2, 20 cm long
Dimensions \(L x W x H\): 48 x 18 x 7.5 mm
Weight: 6.7 g



Load Time: 0 seconds